To successfully wake up a computer via Wake-on-LAN, ensure the following settings and hardware requirements are fulfilled:
You can turn on a sleeping or powered-off computer using TeamViewer ’s Wake-on-LAN feature. This means you can control an offline computer remotely by waking it up first be fore you establish a connection to it. Sep 02, 2012 News: This site uses several active spam blocking measures. Teamviewer for Windows » Wake from sleep/powered off. Wake from sleep/powered off « on: June 29, 2012, 09:21:08 AM » I would like to wake my laptop up from sleep/powered off. Can Teamviewer personal do this? Hero Member; Posts: 904; Re: Wake from sleep/powered off. Being able to put the computer to sleep would be much more efficient; however, the problem then becomes a question of how to wake it up remotely if you do want to access files or media stored on it.
Network card that supports Wake-on-LAN.
Active internet connection.
Connected to the Internet via LAN cable.
Computer should be in any of the following power states:
Sleep Start > Sleep
Hibernate Start > Hibernate
Shut down (Soft off) Start > Shut down
After ensuring that our computer meets the above requirements, you can proceed with configuring your Windows machines for WOL.
Set up Windows
To wake up a computer via WOL, you should enable WOL in BIOS settings and configure network card.
To enable WOL in BIOS settings,
Switch on the computer and press ESC, F1, F2, F8 or F10 during the initial startup. Depending on the BIOS manufacturer, a menu would appear.
Go to the 'Power' tab and enable 'Wake Up On LAN'.
Save and exit the BIOS setup.
Note: If there is no option to enable Wake-on-LAN in BIOS setup, refer to the motherboard manual to ensure your computer supports Wake-on-LAN.
Configure Network Card
The network card must be configured in such a way that the power is supplied all the time.
To configure network card,
Switch on the computer and go to 'Control Panel' -> 'System and Security'.
Click 'Device Manager' displayed on the left navigation bar.
Right-click on 'Network adapters' and click 'Properties'.
Go to the 'Power Management' tab and enable 'Allow this device to wake the computer' option.
How To Set Up Wake-on-lan Teamviewer
Note: The configuration steps may vary depending on the network card and operating system.
Configure Windows 8
In Windows 8 OS the standard shutdown procedure puts the computer into hybrid shutdown state as Windows 8 does not support Wake-on-LAN for this state. Hence we recommend you to deactivate the fast startup. Once fast startup has been deactivated, the computer will always be put into hibernate mode during shut down.
To deactivate the fast startup,
Wake Up Mac From Sleep Teamviewer Free
Wake Up Mac From Sleep Teamviewer 2
Switch on the computer and go to 'Control Panel' -> 'Power Options'.
Click on the 'Change what power buttons do' option on the left menu bar.
Disable 'Turn on fast startup (recommended)' option displayed in the 'Shutdown settings' section.